Taylor Blender shake/slush freezer Manuel d'utilisateur télécharger pdf (Page 15)

Model 432

Important: To the Operator

Section 5 Important: To the Operator

Figure 4

Item

Description

1 Switch- Toggle - 3 PDT

2 Switch- Push Button - SPST

3 Switch- Toggle- SPST - 3/4 HP/250 V

4 Light- Amber- Rect. - 12 VDC - MIX OUT

5 Light- Amber- Rect. - 12 VDC - ADD MIX

6 Viscosity Adjustment

The following chart identifies the symbol definitions

used on the operator switches.

= The “ON/AUTO” button.

= The “OFF” button.

= The “WASH” button.

Control Switch (Item 1)

The center position is “OFF”. The left position is

“WASH”, which activates only the beater motor. The

right position is “AUTO”, which activates the beater

motor and the refrigeration system.

Push- Button Switch (Item 2)

If an overload condition occurs, the freezer will

automatically stop operating. To properly reset the

freezer, place the toggle switch in the “OFF” position.

W ait two or three minutes; then press the push- button

switch. Place the power switch in the “W ASH” position

and observe the freezer’s performance. Place the

power switch in the “AUTO” position.

Note: If the freezer is unplugged from the wall

receptacle, it will be necessary to press the

push- button switch for the freezer to operate once

power is re- established.

Display Light Switch (Item 3)

The display light switch is located under the control

channel. The left position is “OFF”. The right position

is “ON”, and activates the display light.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 41 42

Pas de commentaire

Taylor Blender shake/slush freezer Manuel d'utilisateur Page 15