Taylor Blender shake/slush freezer Manuel d'utilisateur télécharger pdf (Page 24)

Operating Procedures Model 432

Brush Cleaning

Step 1

Prepare a sink with a cleaning solution (examples:

Kay- 5R or Stera- SheenR). USE WARM WATER

AND FOLLOW THE MANUFACTURER’S SPECIFIC-

ATIONS. (If another approved cleaner is used, dilute

according to label instructions. IMPORTANT: Follow

the label directions. Too STRONG of a solution can

cause parts damage, while too MILD of a solution will

not provide adequate cleaning.) Make sure all brushes

provided with the freezer are available for brush

cleaning.

Step 2

Remove the o- ring and seal from the drive shaft.

Remove the o- ring and the bearing from the torque

rotor.

Step 3

Remove the draw valve, ice buster, front bearing, and

gasket from the freezer door . Remove all o- rings.

Note: To remove the o- ring, use a single service

towel to grasp the o- ring. Apply pressure in an upward

direction until the o- ring pops out of its groove. With

the other hand, push the top of the o- ring forward until

it rolls out of the groove and can be removed easily.

Step 4

Thoroughly brush- clean all disassembled parts in the

cleaning solution, making sure all lubricant and mix film

is removed. Place all the cleaned parts on a clean, dry

surfacetoairdry.

Step 5

Return to the freezer with a small amount of cleaning

solution. Brush- clean the rear shell bearing at the

back of the freezing cylinder with the black bristle

brush.

Figure 30

Step 6

Wipe clean all exterior surfaces of the freezer.

Repeat these steps for the other side of the unit.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 41 42

Pas de commentaire

Taylor Blender shake/slush freezer Manuel d'utilisateur Page 24